icetag Christmas Banner

Bicycle Helmet System

Not intended for use with motorcycle helmets. See our specialized motorcycle helmet system.


Bicycle Product cover


The Emergency Data Carrier System incorporates a 2½-cm round, red and white decal that adheres to the outside of the helmet. The external decal is made of a highly reflective material. Emergency and law enforcement personnel can recognize it immediately and know to look inside the helmet for the emergency data sheet slipped into a bright orange plastic carrier envelope. The plastic carrier is attached to the inside of the bike helmet by double-faced tape. The adhesive was tested extensively with high pressure water and steam to ensure that it would adhere well to the inside of any helmet. The information sheet itself is a waterproof, synthetic polyolefin material that resists grease, blood, oil and other stains. The helmet owner uses a pencil to complete the pertinent information, including emergency contacts, medical/surgical history, medications and allergies.

Solution Graphics
Bulk Discounts

'If nothing happens please check your pop-up blocker and try again'

The system has received positive response since its introduction. Medical personnel see it as a lifesaving and timesaving device when every second can make the difference.
Emergency Data Carrier System
(EDCS) is an Emergengy Information decal system for use with safety headgear or helmets. In the event of an emergency, EDCS can provide life-saving Information
about the wearer's identity and medical history.
1. Using a pencil, print
all pertinent information
on the waterproof,
durable Emergency
data/ID form.
Use an eraser to
correct errors and
update data.
2. Fold Data Form in half,
then into thirds. Make sure
your name and the EDCS
logo appear on the outside
panel.
3. Slide the Data Form
into the neon EDCS
carrier so that your
name and the EDCS
logo are visible
through the front of the carrier.
Fold the tab
inside the carrier to
secure the Data Form.
4. Peel off the backing
from the carrier and attach
it to the inside of your helmet.
Attach to any firm, clean, dry
and flat area.
5. Remove the backing
from the EDCS reflective
decal. Apply it to a flat
area on the outside
right rear or top of your
helmet.
   
 
ICETAG
PO Box 946 Wendywood 2144 RSA
Visit us on the web@ www.icetag .co.za
 
Solution Graphics
Bulk Discounts

'If nothing happens please check your pop-up blocker and try again'